If you have the Stromberg Carlson landing gear, part # LG-1, then the replacement lead leg is part # LG-179013. Since you already have the standard 15-1/2 inches between the weld stops on your current jacks you won't need to move the brackets on your trailer. view full answer...
We do have one slide-out actuator available by itself (without the motor) with the Lippert # LC145595.
I wasn't able to track down any information using the part number you found on the sticker but you can compare the dimensions of this unit to yours to see if it will work well as a replacement. This actuator has an overall retracted length of 59 inches and an extended length of 98-3/4 inches. Its stroke length is 40 inches and is designed to work with Tuson Motors.
If one of the teeth... view full answer...
Broken shackles are definitely a problem you don't want to have. For your 2015 CrossRoads Cruiser 345BH I recommend the MORryde Suspension Upgrade Kit for Tandem Axle Trailers # MR46ZR. The kit will replace all of your existing shackles with 1/2" thick heavy duty shackles. It also comes with wet bolts and bronze bushings. This will give you long lasting components you can be confident in and help prevent any future failure on your 5th wheel.
I have attached an installation video below... view full answer...
I believe that you are talking about the Replacement Gearbox # LC276602.
Aside from the rod that comes with the gearbox the only other thing I could think of is the Lead Leg Repair Kit # LC146059 which includes a replacement drive shaft.
Let me know if you were talking about something else and I can see if we carry it.
Please note that the gearboxes can be specific to the 5th wheel landing gear that they fit. view full answer...
The measurements you provided match the measurements of the Lippert Components 32" Lead 5th Wheel RV Landing Gear Drop Leg w/Snap Pin, part # LC179013. The outer tube is 29.5 inches tall by 2.5 inches wide, and the inner tube is 2.25 inches wide. It is a driver leg, and has a drop leg travel of 16 inches.
I've linked to a video review of this landing gear for you to look at. view full answer...
To replace the switch on your Lippert Electric Stabilizer Jack 369777 (which has been replaced with the current model # LC298707), you will just need part # LC387874. This includes the switch and wiring harness so that you can get back to extending and retracting your jack.
I have attached a short video demonstration that you can also check out. view full answer...
I have the Hub and Drum that you need. Thank you for all of the information about your current hubs and axle, it was very helpful. The hubs you will want are the Dexter Trailer Hub and Drum Assembly # 8-201-9UC3-EZ. This includes the hub and drum, Inner bearing: 25580, Outer bearing: 15123 like you have as well as the inner and outer race and the inner and outer grease seals. view full answer...
Go To Results